so i changed my mind. sewing a button is pretty basic, but there’s a couple tricks you might like to know.
step 1: marking the spot
when you try on the pants, mark the place where you want the new button placed. i chose the far end of the button hole, but i made sure it didnt make the pants pucker strangely in the front.
step 2: tying the end of the thread
this is a trick i learned from my mom for tying the end of a thread, single or double. loop the thread around your finger and hold the crossed area between your thumb and your index finger. without moving your thumb, pull your index finger back so that it twists the thread around itself. pull the long end to tie the knot. it takes a bit of practice, but it definitely speeds things up. maybe i’ll do a video on this, its a bit tricky to explain.
step 3: loop it through the button a few times
i did it three times and didn’t make the loops super tight. you’ll see why in the next step.
step 4: secure the button threads
this is something not often done, but its important so that the threads are stable. on the last loop through the button, stop before you puncture the fabric. wrap the thread around threads underneath the button a few times. go through the button holes again and then puncture the fabric to finish.
step 5: closing knot
i accidentally did this without thinking, so now i’m doing this on a scrap piece. to make a secure knot on the back, use your needle as an anchoring point like in the first picture. pull the other end of the thread to make it tight.
when the needle is pas the fabric, press your finger on the cross section and continue pulling through. i tied the thread off after 3 rounds of this, but you can do more or less depending on the fabric.